EDR6D1 Kitchenaid EveryDrop® Ice and Water Refrig

Installation Instructions DIY Guide for Replacing Whirlpool EveryDrop Ice and Water Refrigerator Filter 6 (EDR6D1 – Dark Blue) Are you looking to replace your Whirlpool EveryDrop Ice and Water Refrigerator Filter 6 (EDR6D1 – Dark Blue)? This DIY guide will provide step-by-step instructions on how to do just that! Step 1: Prepare the Filter First, take the filter out of its packaging and let it sit undisturbed for up to 15 minutes to allow the filter media to become saturated. Step 2: Locate the Filter Compartment Find the filter compartment in the refrigerator, usually located on the left side of the refrigerator door. Step 3: Unlock the Filter Unscrew the locking cap from the filter compartment. Step 4: Remove the Old Filter Pull the old filter out of the compartment and discard it. Step 5: Insert the New Filter Hold the new filter with the arrows pointing towards the back of the refrigerator. Push the filter into the compartment until it stops turning. Step 6: Lock the Filter Turn the locking cap clockwise until it locks into place. Step 7: Reset the Filter Change Indicator Finally, reset the filter change indicator on the refrigerator for accurate monitoring of the filter use. And there you have it: you have successfully replaced the Whirlpool EveryDrop Ice and Water Refrigerator Filter 6 (EDR6D1 – Dark Blue)! Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available.